From: Benoit Lecocq Subject: Re: [NEW] cad/xnec2c To: Enzo Nicosia , Date: Tue, 6 Jan 2026 15:16:51 +0100 Le 05/01/2026 à 16:34, Stuart Henderson a écrit : > On 2026/01/05 15:21, Enzo Nicosia wrote: >> On Tue, Dec 30, 2025 at 11:36:32AM +0000, Stuart Henderson wrote: >>> tgz with tweaks attached; >>> >> >> Hello Stuart, and thanks again. >> >>> - don't use github autogenerated tar when upstream has an uploaded one >> >> OK. >> >>> - use standard location for examples (I couldn't figure out where >>> install is done in the makefiles to adjust directly, so just mv'd >>> into place) >> >> I guuess your solution of mobing them in place in post-install is best, >> as the patches to the Makefile.am could be cumbersome and error-prone >> (upstream maintains a list of examples that are allowd with the current >> version, appaarently). >> >>> - don't list ports as LIB_DEPENDS unless they're used directly >>> (e.g. libraries only used as deps of gtk+3) >> >> got that, thanks. >> >>> - small ordering/whitespace tweaks >>> >> >> Those are fine by me. Can I ask if there is a specific reason for having >> space rather than TAB after WANTLIB += ? I think I had used TAB >> consistently for all the other variables (I get and accept your point >> about aligning and ordering, thanks), but I wonder if WANTLIB is somehow >> different? Or += is somehow different? Sorry if I am missing something >> moot here. > > we usually copy and paste these from "make port-lib-depends-check" > without reformatting > >> New tgz attached. It is the same you sent me, where I have removed >> Makefile- (the old Makefile). >> >> Is this OK? > > ok with me if someone would like to import > Imported, thanks !